Before us is a modified version of the well-known naturally aspirated 1.8-liter four-cylinder VW engine, the main innovation of which was the use of turbocharging. The cylinder head in the engine uses a 20-valve, 5 valves per cylinder, with a variable valve timing system on the intake shaft. There are hydraulic lifters so you don’t need to adjust the valves to 1.8T. The timing belt uses a belt, which should be changed every ~ 60,000 km; if the belt breaks, the motor will bend the valve. Continue reading Engine Volkswagen EA113 1.8T
Audi A3
The Audi A3 is a small family car, produced from 1996 to the present by the carmaker AUDI AG. Until 2003, models of the 1st generation were produced, after – the 2nd, and since 2012, cars of the 3rd generation have been manufactured. In 2016, the A3 family was re-styled. Not only the appearance has changed, but the power component, in addition, the cars have received richer and more modern technological equipment. In the modern market, the A3 is presented with 4 body types – sedan, convertible, 3 and 5-door hatchback.
Engine Volkswagen EA113 1.8T
Engine Volkswagen EA827/EA113 1.8
The EA113 1.8 engine of the Volkswagen EA827 segment was released in 1983. This engine was produced in both carburetor and injection versions. In addition to the differences in the injection system, the EA113 1.8 internal combustion engine had a turbocharged and atmospheric version. The turbine appeared on this engine in 1994. The increase in engine power served to increase the demand for the cars where it was installed. Continue reading Engine Volkswagen EA827/EA113 1.8
Engine Volkswagen EA111 1.2 TSI / TFSI
The 1.2 TSI engine is a representative of the EA111 segment in many ways resembles the 1.4 TSI. However, the main distinguishing feature is the cylinder head modification. The 1.2 TSI version has an aluminum cylinder block with wet cast iron liners. The diameter of the piston group has been reduced to 71 mm (originally this figure was 76.5 mm). Continue reading Engine Volkswagen EA111 1.2 TSI / TFSI
Engine Volkswagen EA113 2.0 TFSI
The two-liter engine of the EA113 TFSI series was released in 2004 and was developed on the basis of a naturally aspirated engine with direct fuel injection VW 2.0 FSI. The main difference between the two engines is not difficult to guess from the first letter added – the new engine is turbocharged. This is not the only difference, the power unit must be properly prepared for high power, instead of an aluminum cylinder block, the TFSI uses a cast-iron cylinder block with a modified balancing mechanism with two balancing shafts, uses a different crankshaft with thick persistent tides, pistons modified for a reduced Compression ratio on reinforced connecting rods. Continue reading Engine Volkswagen EA113 2.0 TFSI
Engine Volkswagen EA111 1.4 TSI TFSI
The turbocharged internal combustion engines of the EA111 model (1.2 TSI, 1.4l TSI) began to be installed on the cars of the VAG concern back in 2005. These internal combustion engines have a wide range of various modifications, and have replaced 2.0-liter four-cylinder aspirated engines. The very first engine in this lineup was a 1.4l TSI turbocharged internal combustion engine. Continue reading Engine Volkswagen EA111 1.4 TSI TFSI
Engine Volkswagen EA211 1.2 TSI TFSI
In 2012, one of the most popular engines of the VAG EA111 line (1.2l TSI, 1.4l TSI) was replaced by a completely new EA211 engine. The cylinder head (cylinder head) in the new engine series is rotated 180°, which results in the outlet manifold being integrated into the cylinder head and located at the rear. The timing drive was equipped with a toothed belt instead of a chain – now the timing kit is being replaced as planned by 80-90 thousand km. and is less financially costly. The cylinder block itself is made of aluminum alloy, but with cast iron liners. Continue reading Engine Volkswagen EA211 1.2 TSI TFSI
Engine Volkswagen EA211 1.4 TSI TFSI
The 1.4 TSI engines of the EA211 series are equipped with a turbocharging system paired with an intercooler, which is installed in the intake manifold. Depending on the engine modification, different types of turbines are installed. The main advantage of the new series over the old one is the lower weight of the internal combustion engine and more economical fuel consumption. Continue reading Engine Volkswagen EA211 1.4 TSI TFSI
Engine Volkswagen EA827 1.6
The EA827 1.6L engine was developed back in 1985. It was a block with a short-stroke crankshaft of 77.4mm and cylinder diameters of 81mm. Engine with one camshaft and eight valves in the cylinder head (SOHC 8V). The engine versions with injection technology on the intake shaft were equipped with a variable valve timing system. Adjustment of valve clearances on this engine is not necessary, because there are hydraulic compensators in the motor design. Continue reading Engine Volkswagen EA827 1.6